I've brought several early import sets to life with that.
Make sure the power is off when you do it. The first thing I would do to ANY YaeComWood type rig of that era is pull and re-seat the interconnecting cables. Boy, do we ever miss that! - Noise blankers were meant for mobile use and actually cause receiver overload on a good antenna. The wide setting was supposed to help with the old Soviet over horizon radar.
It will have no effect on line noise or lightning static. If it doesn't do this, or the signal distorts, then you may have a problem.Īs for the NB, it doesn't work on anything except ignition noise. Immediately in FAST AGC and somewhat slower on the slow setting. That being said: Try listening to a signal and remove the antenna. The audio should remain clear at all times with the RF gain at maximum. (Right now, 40Meters at night would be a good test). Frequency stability: Less than 50 Hz after 1 hr.Receiver system: Quadruple conversion super.
A strong SSB signal should be copied with no distortion. It should be set to FAST on AM and SLOW for SSB. If you prefer to be anonymous write it in the message.That's what AGC does is lower the gain to keep from overloading. By click on the link you start a new message thread that only is related to ADI AR-247, and not to any of the articles.Ĭlick here to write a new message or comment for IC-R70 Note that the message is not related to any article.Ĭlick here to see the article list for IC-R70.ĭo you have any tricks, modifications or constructions for homebrewed equipment that are not on mods.dk, please send the information to mods.dk. If you like to write a new message you can do it by click here. There are no messages for this model at the moment. If the message is relate to an article, the article can be selected next to each message. This forum message list include all message for that is related to IC-R70, this include message that also is related to articles. Note that page can take a while to load, if there are many modifications.
0 kommentar(er)
